Eaton Fuller FSO-2405 - Page 154

154
Front Section Assembly
4
Front Section 2nd Ed. 02/07 FSO-2405
FSO-2405/126
37
FSO-2405/31
37
FSO-2405/30
40
38
37. Apply sealant to the thirteen retaining
capscrews that attach the intermediate housing
to the front housing and install the capscrews,
tightening by hand until capscrews are snug.
Next, tighten capscrews crosswise to the proper
torque.
NOTE: Apply Eaton E677 sealant to
capscrews.
Torque = 19-25 N.m (14-19 Lb.ft)
38. From inside the front housing, install the
capscrew that attach the front housing to the
intermediate housing. Tighten capscrew to the
proper torque.
NOTE: Apply Eaton E677 sealant to
capscrews.
Torque = 19-25 N.m (14-19 Lb.ft)
39. Align the shift lug with the shift selecting bar
matching the roll pin holes and install the
retaining roll pin.
NOTE: See “Special Tools”, Ref. E001045.
40. Install the ball, spring and shift positioning plug.
NOTE: Apply Eaton E680 or Eaton E679
sealant to plug threads.
Torque = 10-16 N.m (7-12 lb.ft)
E001045
39