56
Special Tools
1
General Information 2nd Ed. 02/07 FSO-2405
Using the Eaton tool # E006003
This tool is used as an option for locking the transmission mainshaft, allowing transmission
disassembly and assembly by one mechanic only. The tool uses the transmission gear ratio
as a torque amplifier wrench.
E006003/2
Installing the tool # E006003
1. Install the 54 mm special socket (tool
# E006003) on the mainshaft nut and rotate the
shaft until the two holes on the socket match to
the nearest two holes on the housing.
2. Tighten the special socket to the housing with
two housing’s capscrews.
WARNING! Be carefull do not overtighten
the capscrews or leave them loose in
order to avoid damage to the aluminum
housing.
FSO-2405/147
2
FSO-2405/28
3. Shift transmission into 1st gear.
NOTE: With no gear shift lever housing
installed, the gear shift lever pattern is
inverted.
Front
Side
To Next Page
Loading...