58
Special Tools
1
General Information 2nd Ed. 02/07 FSO-2405
1st Gear
FSO-2405/89
4. For tightening the nut, see the following table for the torque to be applied. Use a torquemeter
and rotate clockwise to the calculated torque.
Transmission 1st gear Torque to be
ratio applied
FSO2405A 4.079 54 à 66 N.m
FSO2405B 4.079 54 à 66 N.m
FSO2405C 4.473 49 à 60 N.m
FSO2405D 4.473 49 à 60 N.m
FSO2405E 4.473 49 à 60 N.m
Transmission 1st gear Torque to be
ratio applied
FSO2405F 3.481 63 à 77 N.m
FSO2405G 4.213 52 à 64 N.m
FSO2405H 4.994 44 à 54 N.m
FSO2405J 3.716 59 à 72 N.m
FSO2405K 4.473 49 à 60 N.m
WARNING! Check the vehicle's Service Manual for the transmission to see if the
1st gear ratio matches to the gear ratio informed in the table above. If necessary,
calculate the torque amount as follows.
E006003
E006004 / E006005
Example:
• Specified torque for the nut: 217 a 270 N.m
• Transmission 1st gear ratio: 4.079
Divide 217 by 4,079 and round off to the higher nearest integer:
217/4.079 = 53.199 => use 54
Divide 270 by 4,079 and round off to the lower nearest integer:
270/4.079 = 66.192 => use 66
To Next Page
Loading...