88
Input Shaft Bearing Cover Installation
2
Input Shaft Bearing Cover 2nd Ed. 02/07 FSO-2405
FSO-2405/50
5
5. Apply sealant to the cover’s retaining
capscrews, install them and tighten to the
proper torque.
NOTE:
Apply
Eaton E677
sealant to
the
capscrews.
Torque = 10-16 N.m (7-12 lb.ft)
FSO-2405/53
4
3
FSO-2405/150
FSO-2405/151
E001013
E001021
1. If previously removed, install the new oil seal
with the installer.
NOTE: See “Special Tools”, Ref. E001021,
E001013.
2. Install the oil baffle, observing its correct
position.
3. Apply sealant to the mounting surface of input
shaft bearing cover.
NOTE:
Apply
Eaton E680
sealant to
the
cover.
4. Align the lubrication slots of both input shaft
cover and front housing and install the cover. If
necessary, carefully hit the cover with a plastic
hammer to seat it.
To Next Page
Loading...