92
Rear Section Disassembly
3
Rear Section 2nd Ed. 02/07 FSO-2405
FSO-2405/3
FSO-2405/2
2
3
4
5
6
7
FSO-2405/1
1. Place transmission with the rear cover facing
up.
2. Remove speedometer sensor.
3. Remove the thirteen retaining capsrews of rear
case to the intermediate housing.
4. Use a rubber or plastic hammer to break
gasket seal and detach the rear cover. Remove
the rear cover by pulling it upwards.
5. Remove the speedometer rotor snap ring.
6. Remove the speedometer rotor.
7. Remove the rotor retaining ball from the
mainshaft.
8. Place the wrench to loosen the mainshaft rear
nut.
NOTE: See “Special Tools”, Ref. E006006.
NOTE: As an option, the tool # E006004 or
# E006005 may be used for removing the
mainshaft rear nut, locking the mainshaft
with the tool # E006003. See "Special Tools,
Using the Eaton tool # E006003".
9. Place the special tool and lock the mainshaft.
Loosen the rear nut.
NOTE: See “Special Tools”, Ref. E014010.
10. Remove tools and the mainshaft nut.
FSO-2405/177
8
9
To Next Page
Loading...