Group 90 — Communications
5-64 MVX9000 User Manual
Descriptions of
Parameter Settings
90.04
Transmission Fault
Treatment
Range: Default: 03
00 Display Fault and Continue Operating
01 Display Fault and RAMP to Stop
02 Display Fault and COAST to Stop
03 No Fault Displayed and Continue Operating
90.05
Over-time Detection
(Watch Dog Timer)
Range: Default: 0.0
0.1 – 120.0 seconds
0.0 Disable
This parameter is used for communication loss. When this
parameter is set to any value over 0.0, the timer is enabled.
The value set in this parameter is the time allowed between
two command strings.
To Next Page
Loading...
