NZM-XDMI-DPV1
(PROFIBUS-DPV1 Interface for
DMI)
112
11/04 MN01219002Z-EN
Stations address DP
master
Contains the station address of the
DP master
–
Status specifier NZM-XDMI-DPV1 does not issue a
“incoming/outgoing” message to
the sent diagnosis information
(status): hexadecimal 00
–
Status type
The NZM-XDMI-DPV1 uses the
“Status message” type status:
hexadecimal 81
–
Stop of DMI: CB with
new serial number
connected
A circuit-breaker with a new serial
number has been connected to the
DMI
Ensure that it is the desired type
Acknowledge it via the DMI
keypad or via the PROFIBUS
with the aid of the circuit-
breaker/DMI command object
Sync mode active
The DP master has activated the
synchronous output of data outputs
to multiple stations
Intended user action
Watchdog activated
The connection monitoring in the
NZM-XDMI-DPV1 has been activated
correctly
Desired state
Designation
Meaning Clarification/Hint
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
