Eaton NZM3 - Page 119

NZM-XDMI-DPV1
(PROFIBUS-DPV1 Interface for
DMI)
114
11/04 MN01219002Z-EN
• Currents in the circuit-breaker (I
rms
of the 3 phases and
the neutral pole, maximum current, fault current),
• DMI functionality (motor-starter function, assignment of
the DMI outputs with switching signals),
• DMI display (assignment of the individual display lines),
• DMI parameters (password, language selected, serial
number, start configuration),
•DMI clock,
• State of the inputs of the DMI,
• State of the outputs of the DMI,
• DMI identification (software version),
• NZM-XDMI-DPV1 identification (software version),
• Communication status (circuit-breaker, DMI, start-up),
• Statistical values (circuit-breaker/DMI operating hours,
circuit-breaker switching operations).
The following functions can be controlled or parameterized:
• Commands on the circuit-breaker (switch on, switch off,
trip),
• Commands on the DMI (switch off motor, switch on
motor, anticlockwise, clockwise, acknowledge stop mode,
acknowledge alarms),
• Parameters to be used in the circuit-breaker
(e.g, limitation values and delay times for overload, short
circuit and fault current),
• DMI functionality (motor-starter function, assignment of
the DMI outputs with switching signals),
• DMI display (assignment of the individual display lines),
• DMI parameters (password, language selected, serial
number, start-up),
•DMI clock.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com