Eaton NZM3 - Mounting

Engineering and installation
17
11/04 MN01219002Z-EN
Carry out the installation of the DMI in the following order:
• Mounting,
• Wire inputs,
• Wire outputs,
• Connect the power supply.
Mounting
Install the DMI in a control panel, service distribution board
or enclosure so that during operation the power supply
connections and the terminals are protected against direct
contact.
Snap fit the DMI onto a top-hat rail which is conform to IEC/
EN 60715. The DMI can be mounted vertically or
horizontally.
For problem-free wiring of the DMI, ensure a clearance on
the terminal sides of at least 30 mm to the wall or to
neighbouring devices.
h
When using the DMI with expansion modules (e.g.
fieldbus modules, PROFIBUS-DP) connect the expansion
module before mounting.
30 mm
(1.18“)
30 mm
(1.18“)
30 mm
(1.18“)
30 mm
(1.18“)
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com