Eaton NZM3 - Function; Direct-On-Line Starter

Parameter setting
45
11/04 MN01219002Z-EN
Figure 7: Operating principle for motor starter function with DMI
Function
This specifies the function of the DMI. In other words, either
the basic DMI functions or one of the following types of
motor starter function:
• Direct-on-line starter
Selecting DOL causes the motor to start directly, without any
additional changeover. Only one direction of rotation is
possible.
The inputs are used according to the type of control circuit
devices selected.
Inputs I1 to I3
NZM
NZM-DMI612
Outputs Q0 to Q3
Contactor(s)
L1 L2 L3
24 V DC
Manual operation
(switch/Pushbutton)
NZM-XDMI-CAB
Interface
Fieldbus
Control cable(s)
Motor
FUNCTION
Off
DOL
Rev. starter
S/D rev. st.
S/D rev. st.
Inputs: Switch I1 ON/OFF
Pushbut
tons
I1 ON
I2 OFF
Outputs: Q0 Mains
contactor
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com