Diagnostics
61
11/04 MN01219002Z-EN
Alarm
The Alarm submenu uses the listed parameters to show you
the cause of a currently present alarm message of the circuit-
breaker.
The meaning of the respective output functions can be found
at a table 1, Page 42.
NZM Info
The NZM Info submenu provides information for the
identification of the circuit-breaker.
NZM Mode
The NZM Mode submenu shows you whether the circuit-
breaker power supply is sufficient (Power OK [Y/N]) and
whether it is being supplied from an external source or by
itself. Ext.Power (Y/N)
The external power supply is normally provided by the DMI.
The circuit-breaker uses its own power supply when working
without a DMI or other communication partner.
When operating the circuit-breaker in conjunction with the
DMI, “Power OK” and “Ext. Power” must be set to “Y”.
ALARM
Load Warning
Overload 1
Overload 2
Unbalance
NZM INFO
(frame size)
(function)
IEC or UL/CSA
In
Ser. No.
SW Version
Module Type
Mod SW Vers.
Line 1: Frame size (NZM2,3,4)
Line 2: Function (AE, ME, VE etc.)
Line 3: Rated current (stated in Amps)
Line 4/5: Serial number
Line 6: Software version
Line 7: Module type (module ID if NZM4 module
fitted)
Line 8: Module software version
NZM MODE
Power OK (Y/N)
Ext.Power (Y/N)
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
