Eaton NZM3 - Installation; Connect the Power Supply

NZM-XDMI-DPV1
(PROFIBUS-DPV1 Interface for
DMI)
78
11/04 MN01219002Z-EN
• identified,
• parameterized
• controlled
•monitored,
• diagnosed,
via the PROFIBUS DP from a higher-level master.
Installation Connect the power supply
The NZM-XDI-DPV1 is operated by a 24 V DC supply voltage
(a section “Technical data”, Page 68).
Figure 15: Standard connection
Warning
With the 24 V power supply, ensure a safe electrical
isolation of the low voltage (SELV).
+24 V
> 1 A
0 V
+24 V 0 V
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com