Eaton PDI WaveStar BCMS Hub Installation and Operation Manual P-164001108—Rev 01 31
CChhaapptteerr 55 OOppeerraattiioonn:: DDeevviiccee IInnffoorrmmaattiioonn
The BCMS Hub retrieves and displays information from the points list of each of its monitored devices.
Information includes alarms, warnings, power measurements, and device parameters, such as circuit breaker
amperage and alarm thresholds.
55..11 HHoommee SSccrreeeenn
Figure 22. Home Screen
55..22 SSttaarrttuupp SSccaannss
At startup, the BCMS Hub scans for devices in the Hub’s device chain. The Hub recognizes device types from
device IDs on PCBs, which are then displayed under the “Device” header on the Home screen. The first scan
after startup is slow as the Hub builds its device chain; subsequent scans are faster. “No Device” is displayed
when the Hub receives no response from a Modbus address.
An authorized user can touch Reset to require the Hub to rebuild its device chain from scratch.
To Next Page
Loading...
