www.eaton.com IM02601001E C-59
Modbus Register Maps
Settings Registers for Analog Out 0-1mA / Analog Out 4-20mA Cards Second Overlay write only in PS update
mode
7D3F
-
7D3F 32064
-
32064 Update rate UINT16 0 to 65535 milliseconds Set to 0. 1
7D40 - 7D40 32065 - 32065 Channel direction - 1mA Card only! UINT16 bit-mapped -------- ----4321 Full range output for
0-1mA card only: A bit
set(1) means full range
(-1mA to +1mA); a bit
cleared(0) means source
only (0mA to +1mA).
1
7D41 - 7D41 32066 - 32066 Format parameter for output #1 UINT16 bit-mapped -------- ---f suwb Format of the polled
register:f=float 32;
s=signed 32 bit int;
u=unsigned 32 bit int;
w=signed 16 bit int;
b=unsigned 16 bit int.
1
7D42 - 7D42 32067 - 32067 Source register for Output#1 UINT16 0 to 65535
This register should be
programmed with the
address of the register,
whose value is to be
used for current output.
In different words, the
current level output
of analog board will
change with the value
of the register pointed
here.
1
7D43 - 7D44 32068 - 32069 High value of source register for output#1 Depends on the format parameter Value read from the
source register at which
High nominal current
will be output. Ex-
ample: for the 4-20mA
card, if this register is
programmed with 750,
then the current output
will be 20mA when the
value read from the
source register is 750.
2
7D45 - 7D46 32070 - 32071 Low value of source register for output#1 Depends on the format parameter Value read from the
source register at which
Low nominal current
will be output. Ex-
ample: for the 4-20mA
card, if this register is
programmed with 0,
then the current output
will be 4mA when the
value read from the
source register is 0.
2
7D47 - 7D4C 32072 - 32077 Analog output#2 format, register, max &
min
Same as analog output #1. 6
7D4D - 7D52 32078 - 32083 Analog output#3 format, register, max &
min
Same as analog output.#1. 6
7D53 - 7D58 32084 - 32089 Analog output#4 format, register, max &
min
Same as analog output #1. 6
To Next Page
Loading...
