Eaton Power Xpert 9395P - Figure 5-3. Distributed Bypass System CAN and Pull-Chain Simplified Interface Wiring; Figure 5-4. Distributed Bypass System UPS CAN Wiring Without Mobs

P-164000476 9395P 500kVA / 600 kVA 57
Revision 002 User’s and Installation Guide
Figure 5-3. Distributed bypass system CAN and Pull-Chain simplified interface wiring
NOTE
This drawing is for distributed bypass wiring purposes and is not a floor layout plan. UPSs can
be placed in any physical order.
Figure 5-4. Distributed bypass system UPS CAN wiring without MOBs
NOTE
External CAN connections between UPSs require shielded twisted pair wire.
From
UPS 1 CAN Bridge Card
To
UPS 2 CAN Bridge Card
To
UPS 3 CAN Bridge Card
(if installed)
To
UPS 4 CAN Bridge Card
(if installed)
J3-8 (L) J3-8 (L) J3-8 (L) J3-8 (L)
J3-9(H) J3-9(H) J3-9(H) J3-9(H)