Eaton Power Xpert C445 - Page 317

Appendix D—Modbus Register Map
Power Xpert C445 Global Motor Management Relay MN042003EN—January 2019 www.eaton.com 303
312 Active Fault UINT16 RO
Default: 0
Enum
Current Active Fault
Table 128. C445 Modbus Register Map, continued
Register Name Attribute Description
Value Description
0 No Faults
1 Under voltage
2 Over voltage
3 Reserved
4 Ground current fault
5 Current phase loss
6 Current unbalance
7 Instantaneous over current
8 Jam
9 PF Deviation
10 Voltage phase loss
11 Voltage unbalance
12 Frequency deviation fast
13 Frequency deviation slow
14 Under current
15 High power
16 Low power
17 Contactor failure
18 Starts limit exceeded
19 Overload
20 Stall
21 Phase rotation mismatch
22 PTC - See PTC State for
details
23 Under voltage restart
24 Measurement Module fault
25 Communication loss on active fieldbus
26 Measurement Module not available or communication loss
with the module
27 User Interface not available or communication loss with the
module
28 Test trip was triggered
29 Option Card not available or communication loss with the
module
30 RTC / Backup Memory Option Board NV memory fail
31 Currently connected User Interface does not match with
what was connected before
32 Currently
connected Measurement Module does not match
with what was connected before
33 Currently connected Option Card does not match with what
was connected before
34 Measurement Module firmware is incompatible
35 User Interface firmware is incompatible
36 Ethernet Option Card firmware is incompatible
37 Profi Option Card firmware is incompatible