Eaton PowerXL DA1 - Catalog Number Selection

1 DA1 device series
1.4 Rated operational data
16 DA1 Variable Frequency Drives 11/16 MN04020005Z-EN www.eaton.com
1.4.2 Catalog number selection
The catalog number selection/part no. for DA1 variable frequency drives is
subdivided into three groups
Series – Power section – Model
The following figure shows it in greater detail:
Figure 8: Catalog number selection
D A 1 - 1 2 4 D 1 F B - A 2 0 C Explanation
Type
C = additional PCB protection (coated board)
Degree of protection
20 = IP20/NEMA 0
55 = IP55/NEMA 3
66 = IP66/NEMA 4X
6S = IP66 with switch/NEMA 4X, switched
Display unit (display)
A = LED display
B = OLED display
Brake Chopper
B = Brake chopper
EMC (radio interference suppression filter)
N = No internal RFI filter
F = Internal RFI filter
Rated operational current (examples)
2D2 = 2.2 A
024 = 24 A
450 = 450 A
Mains voltage category (rated value)
2 = 230 V (200 - 240 V ±10 %)
4 = 400 V (380 - 480 V ±10 %)
5 = 575 V (500 - 600 V ±10 %)
Connection in power section
1 = single-phase mains connection/three-phase motor
3 = three-phase mains connection/three-phase motor
Device series
DA1 = Variable frequency drive, advanced, Series 1
(D = Drives, A = Advanced, 1 = Series)