3 Installation
3.3 Mount ing
DA1 Variable Frequency Drives 11/16 MN04020005Z-EN www.eaton.com 79
To do this, place the variable frequency drive on the mounting rail from
above [1] and press it down until it snaps into place [2].
Figure 44:Fixing on mounting rails
Dismantling from mounting rails
To remove the device, push down [2] on the clip being held by a spring
force [1]. There is a marked recess at the bottom edge of the device that
is intended for this purpose.
A flat-bladed screwdriver (blade width 5 mm) is recommended for
pushing down the clip.
Figure 45:Dismantling from mounting rails
Now pull the lower edge away from the mounting surface (towards you)
[3] before lifting the variable frequency drive off the mounting rail.
2
1
E
M
C
V
AR
To Next Page
Loading...
