Eaton PowerXL DC1 20 Series - Handling the Keypad; Operating Unit Elements

4 Operational
4.5 Handling the keypad
128 DC1…20… and DC1…OE1 Variable Frequency Drives 02/20 MN040059EN www.eaton.com
4.5 Handling the keypad
The keypad can be used to configure the DC1 variable frequency drive’s
parameters and monitor its operation.
4.5.1 Operating unit elements
The following figure shows the elements of the DC1 variable frequency drive
integrated operating unit.
Figure 74:Operating unit view (example DC1-…-A20…)
￫
Manual MN040022EN, “DC1 Variable Frequency Drives –
Parameter Manual”, goes over how to configure the individual
parameters.
Display (7-digital LEDs)
Push buttons
￫
If you intend to use an external keypad and/or a parameter
copying stick with the DC1-…E1 variable frequency drive, please
note that only models DX-KEY-LED2 and DX-COM-STICK3 will
work.
DX-KEY-OLED can be used, but requires an update first.
￫
The integrated keypad on DC1 devices and the (optional)
external DX-KEY-LED2 keypad feature a six-digit 7-segment LED
display.
The optional DX-KEY-OLED keypad is a multi-language cleartext
display unit (OLED = Organic light-emitting diode).
It can be used in conjunction with DC1 variable frequency
drives. The buttons on both keypads work the exact same way.
The additional Hand and Auto buttons on the DX-KEY-OLED
keypad do not do anything in this case.