Eaton PowerXL DC1 20 Series - Page 136

4 Operational
4.5 Handling the keypad
132 DC1…20… and DC1…OE1 Variable Frequency Drives 02/20 MN040059EN www.eaton.com
4.5.3.3 Extended parameter set
Table 26: Enabling and disabling access to the extended parameter set
Commands
Description
Enabling access to the extended parameter set
Press the OK button and hold it down for two seconds in
order to access the parameter interface
The display will show the parameter that was last used.
Use the ▲ and ▼ buttons to select parameter P-14
Press the OK button.
Use the ▲ and ▼ buttons to enter the password set with
P-37 (default setting: 101)
Press the OK button to confirm
The extended parameter set (parameters > P-14 and
display values P00-…) will now be available.
Disabling access to the extended parameter set
Use the ▲ and ▼ buttons to set a value for P-14 that does
not match the password (P-37).
Press the OK button to confirm
Only the “basic parameters”, P-01 to P-14, will be
accessible now.
￫
The extended parameter set (default setting for P-37 = 101)
contains parameters P-01 to P-55.
Additional parameters P-60 to P-68 can be configured for
specific applications. The corresponding password is 201 in
parameter P-14 (value of P37 + 100).