Eaton PowerXL DC1 20 Series - Page 152

6 Technical Data
6.1 General rating data
148 DC1…20… and DC1…OE1 Variable Frequency Drives 02/20 MN040059EN www.eaton.com
Control section
Control Voltage
Output voltage (control signal terminal 1) U
C
V DC 24
Load rating (control signal terminal 1) I
1
mA 100
Reference voltage (control signal terminal 5) U
S
V DC 10
Load rating (control signal terminal 5) I
5
mA 10
Digital Input (DI)
Quantity 2 - 4
Logic (level) increase (NPN)
Response time t
r
ms < 8
Input voltage range High (1) U
C
V DC 8 - 30
Input voltage range Low (0) U
C
V DC 0 - 4
Analog Input (AI)
Quantity 0 - 2
resolution 12-bits
accuracy % < 1 to the final value
Response time t
r
ms < 16
Input voltage range U
S
V 0 - 10, DC (R
i
~ 72 kΩ)
Input current range I
S
mA 0/4 - 20 (R
B
~ 500 Ω)
Relay output (RO1)
Quantity 1 relay
Relay contact N.O.
Switching capacity
AC I A 6 (250 V AC)
DC I A 5 (30 V AC)
Digital Output (DO)
Quantity 0 - 1
Output voltage U
Out
V +24
Load rating (control signal terminal 8) I
8
mA 20 max.
Analog Output (AO)
Quantity 0 - 1
Output voltage U
Out
V 0 - +10
Load rating (control signal terminal 8) I
8
mA 20 max.
resolution Bit 10
accuracy % < 1 to the final value
Interface (RJ45) OP bus, Modbus RTU, CANopen, RS485
Response time (after valid command) t
r
ms < 8 (Modbus, CANopen)
< 8 (OP bus: Master slave, 60 ms cycle)
Technical data Symbol Unit Value