Eaton PowerXL DC1 Series - DX-Spl-Rj45-2 Sl1 Pl

11 Annex
11.6 DX-SPL-RJ45-2SL1PL
DC1 variable frequency drive 12/13 MN04020003Z-EN www.eaton.com 187
11.6 DX-SPL-RJ45-2SL1PL
This splitter was specifically designed for networking multiple variable
frequency drives. The RJ45 ports are connected in parallel so as to make it
possible to connect multiple variable frequency drives or up to two external
keypads with a simple RJ45 cable.
Figure 96: DX-SPL-RJ45-2SL1PL
The RJ45 connector needs to be plugged into the front of the DC1 variable
frequency drive. The sockets can be used to connect another variable
frequency drive, an external keypad, or a head-end controller (via a field bus).
Figure 97: Connection
a variable frequency drives
b Splitter DX-SPL-RJ45-2SL1PL
c RJ45 Cables

L1/L
L2/N
L3

U
V
W
1
2
3
4
5
6
7
8
9
10
11
①
②
③