4 Operation
4.5 Commissioning with keypad
DC1 variable frequency drive 12/13 MN04020003Z-EN www.eaton.com 91
3 Press the Start button to start the variable frequency
drive.
It will then run with the acceleration time set in P-03 all
the way to the setpoint value on the keypad.
You can use the ▲ and ▼ arrow keys to change the
setpoint value in RUN mode.
4
Pressing the Start pushbutton again will change the
operating direction (P-12 = 2).
Note:
When the REV operating direction is in effect, the
frequency will have a minus sign.
FWD
REV
Minus sign for REV operating direction
5
When the Stop pushbutton is pressed, the variable
frequency drive will be stopped with the deceleration
time configured in P-04.
Sequence Commands View Description
To Next Page
Loading...
