Eaton PowerXL DG1 Series VFD - Figure 14. Static IP Mode

To Next Page

To Previous Page

Modbus TCP On-Board Communications

20 PowerXL DG1 Series VFD MN040010EN—May 2014 www.eaton.com

Manual IP Address Configuration

Using the PowerXL Drive Keypad

Using the PowerXL Drive Keypad to set the IP Address

manually in the PowerXL EtherNet/IP.

1. Select IP addressing mode as Default static IP

configurations will be loaded.

Note: Change in IP address mode will require PowerXL

to power cycle to get this change effective. Also ensure

device MAC address (Keypad menu. P20.3.5)

Figure 14. Static IP Mode

Other manuals for Eaton PowerXL DG1 Series VFD