Eaton PowerXL DH1 Series - Page 5

v
PowerXL DH1 series variable frequency drives
POWERXL DH1 SERIES ADJUSTABLE FREQUENCY DRIVES MN040041EN—August 2019 www.eaton.com
Table of contents, continued
Basic application control I/O configuration .................................31
Control I/O configuration ..............................................33
Basic application—parameters list .......................................33
Monitor ............................................................33
Parameters .........................................................36
Inputs ..............................................................36
Outputs ............................................................40
Drive Control ........................................................42
Motor Control .......................................................44
Protections .........................................................44
Communication ......................................................48
RS485 Bus ..........................................................50
EtherNet Bus ........................................................51
System. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .52
Chapter 6 — PID Application
Introduction ........................................................55
I/O controls .........................................................55
Force open/force close selection ........................................56
DIGIN selection .....................................................56
Option board DigIN selection ...........................................56
Timer channel selection ................................................56
Control I/O configuration ...............................................57
PID application—parameters list .........................................58
Parameters .........................................................63
Inputs ..............................................................63
Outputs ............................................................67
Drive Control ........................................................70
Motor Control .......................................................71
Protections .........................................................72
Setpoint ............................................................76
Feedback ...........................................................78
Feedforward ........................................................79
PID Controller 2 ......................................................79
Setpoint ............................................................80
Feedback ...........................................................81
Feedforward ........................................................82
Bypass .............................................................83
Real Time Clock ......................................................84
Communication ......................................................85
RS485 Bus ..........................................................87
EtherNet Bus ........................................................88
System. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .89