Eaton PowerXL DH1 - Appendix A-Technical Data and Specifications; Technical Data; Table 42. Powerxl Series

56
Appendix A—Technical data and specifi cations
POWERXL SERIES VFD MN040002EN—February 2018 www.eaton.com
Appendix A—Technical data and speci cations
Technical data
Table 42. PowerXL Series
Attribute Description Specification
Input ratings Input voltage Uin 208 V to 240 V, 380 V to 500 V, 525 V to 600 V, –15 to 10%
Input frequency 50 Hz to 60 Hz (variation up to 45 Hz to 66 Hz)
Connection to power Once per minute or less
Starting delay 3 s (FR0 to FR2), 4 s (FR3), 5 s (FR4), 6 s (FR5 and FR6)
Short-circuit withstand rating 100 kAIC (fuses and circuit breakers)
Output ratings Output voltage 0 to Uin
Continuous output current I
L
: ambient temperature maximum 40 °C, up to 60 °C with derating, overload 1.1 x I
L
(1 min./10 min.)
I
H
: ambient temperature maximum 50 °C, up to 60 °C with derating, overload 1.5 x I
H
(1 min./10 min.)
Overload current 150% respectively 110% (1 min./10 min.)
Initial output current 200% (2 s / 20 s) based of the drives rated nameplate I
H
current rating.
Output frequency 0–400 Hz (standard)
Frequency resolution 0.01 Hz
Control characteristics Control methods Frequency control
Speed control
Open-loop speed control
Open-loop torque control
Switching frequency 230 V / 480 V Range:
 FR0–3: 1 kHz to 12 kHz
 FR4–6: 1 kHz to 10 kHz
230 V / 480 V defaults:
 FR0–3: 4 kHz
 FR4–5: 3.6 kHz
 FR6: 2 kHz
600 V range:
 FR1–6: 1 kHz to 6 kHz
600 V defaults:
 FR1–6: 1.5 kHz
Automatic switching frequency derating in case of overload.
Frequency reference Analog input: resolution 0.1% (10-bit), accuracy +1%
Analog output: resolution 0.1% (10-bit), accuracy +1%
Panel reference: resolution 0.01 Hz
Field weakening point 20 Hz to 400 Hz
Acceleration time 0.1 s to 3000 s
Deceleration time 0.1 s to 3000 s
Braking torque DC brake: 30% x Motor Rated Torque (Tn) (without brake chopper)
Dynamic braking (with optional brake chopper using an external brake resistor):
100% continuous maximum rating
Ambient conditions Ambient operating temperature –10 °C (no frost) to +50 °C, up to +60 °C with derating (CT)
–10 °C (no frost) to +40 °C, up to +60 °C with derating (VT)
Storage temperature –40 °C to +70 °C
Relative humidity 0–95% RH, noncondensing, non-corrosive
Air quality:
• Chemical vapors
• Mechanical particles
Tested according to IEC 60068-2-60 Test Key:
 Flowing mixed gas corrosion test, Method 1 (H2S [hydrogen sulfide] and SO2 [sulfur dioxide])
Designed according to:
 IEC 60721-3-3, unit in operation, class 3C2
 IEC 60721-3-3, unit in operation, class 3S2