38
EtherNet/IP On-Board Communications
POWERXL SERIES VFD MN040010EN—June 2018 www.eaton.com
2. Using drive keypad, set the IP address to the desired address setting by:
a. Setting Static IP Address
Figure 26. DG1 Static IP address
b. Setting Static Subnet Mask
c. Setting Static Default Gateway
3. Make note of the changed IP Address.
4. Using drive keypad, read “Active IP Address”, “Active
Subnet Mask”, “Active Default Gateway” parameters to
ensure that IP address has been set to desired setting.
To Next Page
Loading...
