47
Appendix A—Technical data and specifications
POWERXL SERIES VFDS MN040060EN—September 2020 www.eaton.com
Table 27. PowerXL DM1 Series specifications (continued).
Section Description Specification
Protections Overvoltage protection Yes
Overvoltage trip limit 115 V 1-phase: 430 Vdc
230 V 1-phase: 430 Vdc
230 V 3-phase: 430 Vdc
480 V 3-phase: 850 Vdc
Undervoltage protection Yes
Undervoltage trip limit 115 V 1-phase: 175 Vdc
230 V 1-phase: 175 Vdc
230 V 3-phase: 210 Vdc
480 V 3-phase: 390 Vdc
Earth fault protection Yes
Input phase supervision Yes
Motor phase supervision Yes
Overcurrent protection Yes
Unit overtempurature protection Yes
Motor overload protection Yes
Motor stall protection Yes
Motor underload protection Yes
DC bus overvoltage control Yes
Short-circuit protection of 24V supply No
Surge protection Yes (differential mode 2 kV; common mode 4 kV)
Control section Control voltage 24 Vdc, max 100mA
Reference voltage 10.3 Vdc max 10mA
Digital Inputs:
• Quantity 4 programmable
• Type Positive or negative logic; 18 to 30 Vdc,
• Maximum switching speed 1 kHz
Relay output:
• Quantity 2 programmable (1 Form C relay and 1 N/O form A relay)
Note: DM1 pro only. DM1 has only 1 form A relay on board
• Specification Switching capacity:
• Resistive rating: 3.0 A @ 30 Vdc, 3.0 A @ 125 V, 3.0 A @ 240 Vac
• Inductive rating: 0.5 A @ 30 Vdc, 0.5 A @ 125 V, 0.5 A @ 240 Vac
Analog Input:
• Quantity 1 dipswitch selectable 0-10 Vdc or 0/4 to 20 mA
• Specification
Resolution
0-10 Vdc analog
4-20 mA analog
External pot
10-bit
100k ohm input impedance
250 ohm input impedance
1-10kohm, 2 watt minimum
Analog Output:
• Quantity 1 dipswitch selectable 0-10Vdc or 4 to 20mA
• Specification
Resolution
0-10 Vdc analog
0/4-20 mA analog
10-bit
10 mA max
RL max 500 ohm
Communications Ethernet I/P Onboard *(DM1 Pro only)
Modbus TCP Onboard *(DM1 Pro only)
BACnet I/P Onboard *(DM1 Pro only)
Modbus RTU Onboard
BACnet MSTP Onboard *(DM1 Pro only)
Dualport ethernet I/P Optional *(DM1 Pro only)
SmartWire D/T Optional *(DM1 Pro only)
Profibus Optional *(DM1 Pro only)
CANOPEN Optional *(DM1 Pro only)
To Next Page
Loading...
