Eaton PowerXL Series - Commissioning; Figure 40. PROFIBUS Parameter Menu

83
PROFIBUS-DP External Communication Cards
POWERXL SERIES VFD MN040010EN—June 2018 www.eaton.com
Commissioning
The PROFIBUS board is commissioned by inserting it into
the Slot A or Slot B on the drive control board. Once the
card is inserted to the slot, the device will recognize it and
will show a warning for “Device Added.” This warning will
be shown for 5 seconds and will be cleared. Once the card
is detected, the keypad will show the menu for this card in
Optional Card Menu.
Optional comm cards parameters
Once the card is detected, following parameters can be set
on keypad for the PROFIBUS.
Figure 40. PROFIBUS parameter menu
JOG13:53
STP FWD KEY TPM
P: Parameter
F: Fault
Down key until
Optional Board
Group
M: Monitor
JOG13:53
STP FWD KEY TPM
B: Optional Boards
T: Favorite
F: Fault
Menu13:53
STP FWD KEY BOA
B7: Slot A: Profibus
B11: Slot B: No Board
Right/OK key
Reverse
Me
n
13:53
STP FWD KEY B
O
B7.1: Monitor
Reverse
Right/OK key
B7.2: Parameter
Menu13:53
STP FWD KEY BOA
B7.1.1: Board Status
B7.1.3: Protocol Status
Reverse
B7.1.2: Firmware Version
Down Arrow
key to set
Parameters,
Right/OK key
Right/OK key
or down key
to desired
parameter