Eaton PowerXL - Control Signal Terminals; Correspondence between Inputs;Outputs and Terminals

6 Parameter structure
6.4 Control signal terminals
DC1-S…20…, DC1-S…OE1 Variable Frequency Drives 05/21 MN040058EN www.eaton.com 123
6.4 Control signal terminals
6.4.1 Correspondence between inputs/outputs and terminals
Parameter P-15 can be used to select the configuration for the control signal
terminals. More specifically, you can select predefined terminal
configurations by setting P-15 to a value between 0 and 13.
The setting (digital/analog) for terminals 4 and 6 will be configured
automatically based on the value set for P-15.
Input/Output Clips
Input points
DI1 Terminal 2
DI2 Terminal 3
DI3/AI2
Terminal 4
DI4/AI1
Terminal 6
Outputs
AO1/DO1 Terminal 8
RO1 (relay, N/O) Terminals 10/11