Eaton Corporation Page 21 Ver 1.1
ii) There are 2 types of handling modes to install the mounting bracket
on a wall. The user can use the different screwing points as
appropriate. The corner screwing points or the central screwing point
as illustrated in the figures, below. To secure the mounting bracket,
mark 6 outer holes on the wall, drive in the 6 mounting anchors, then
screw in the 6 M4 screws to each screwing point as illustrated below:
Figure 5.4.5: Corner screwing fixing mode
Figure 5.4.6: Central Point Fixing Mode
Type A handling mode
Type B handling mode
To Next Page
Loading...
