Eaton Corporation Page 72 Ver 1.1
E) DC Inj. high
Fault Conditions: Input DC injection too high.
Corrective Actions:
Check the connection of the DC Input.
Restart the PV Inverter.
If fault remains, disconnect the PV Inverter and contact the system
installer.
F) EEPROM Failures
Conditions: EEPROM inside has data access problem.
Corrective Actions:
Restart the PV Inverter.
If fault remains, disconnect the PV Inverter and contact the system
installer.
G) SCI failure
Conditions: Communication between MCU inside is abnormal.
Corrective Actions:
Restart the PV Inverter.
If fault remains, disconnect the PV Inverter and contact the system
installer.
H) High DC bus
Conditions: The DC BUS inside is higher than expected.
Corrective Actions:
Restart the PV Inverter.
If fault remains, disconnect the PV Inverter and contact the system
installer.
To Next Page
Loading...
