7 Parameterization
Rapid Link 5 · RAMO5 · RASP5 05/20 MN034004EN www.eaton.com 157
3. Connect the module to the external control unit using a patch cable
with an RJ45 plug.
Figure 97: Connection to the external control unit using a patch cable with an RJ45 plug
￫
The components listed here are not included as standard (optio-
nal accessories).
ATTENTION
Changing the parameter range to P1-14 = 201 requires additio-
nal configuration and meticulous parameter settings.
The operation and function of the Rapid Link 5 may considerably
deviate from the standard settings of the Rapid Link 5 system
and lead to different operating statuses.
To Next Page
Loading...
