Eaton SLX9000 - Input Signals; Figure 9-1: Jumper Selections of X4;X8 When AI1 Functions as DIN4

SLX9000 Adjustable Frequency Drives User Manual
9-6 For more information visit: www.eaton.com
MN04003020E
January 2009
Input Signals
Figure 9-1: Jumper Selections of X4/X8 When AI1 Functions as DIN4
2.1.21 Automatic restart function ID731
The automatic restart is taken into use with this parameter.
0 Disable
1 Enabled (3 automatic restarts, see par. 2.8.1 – 2.8.3)
2.1.22 Parameter conceal ID115
With this parameter you can hide all other parameter groups except the basic
parameter group (B2.1).
The factory default of this parameter is 0.
0 Disabled (all parameter groups can be browsed with the keypad)
1 Enabled (only the basic parameters, B2.1, can be browsed with the
keypad)
2.2.1 Expander board DIE1 function ID368
This parameter has 12 selections. If the expander board digital input DIN1 is not
used, set the parameter value to 0.
Selections are the same as in parameter 2.1.18, except:
13 Interlock 1
2.2.2 Expander board DIE2 function ID330
The selections are the same as in parameter 2.2.1, except:
13 Interlock 2
2.2.3 Expander board DIE3 function ID369
The selections are the same as in parameter 2.2.1, except:
13 Interlock 3
2.2.4 DIN4 Function ID499
If the value of par. 2.2.6 is set to 0, AI1 functions as digital input 4.
The selections are the same as in parameter 2.2.3.
Note: If you program the analog input as DIN4, check that the jumper selections are
correct (see Figure 9-1).
Voltage Input; 0...10V
Jumper Block X8: