Eaton SLX9000 - Figure 4-5: Location of Jumper Blocks in the Control Board of

SLX9000 Adjustable Frequency Drives User Manual
4-8 For more information visit: www.eaton.com
MN04003020E
January 2009
CAUTION
Check the correct positions of the jumpers. Running the motor with
signal settings different from the jumper positions will not harm the
drive but may damage the motor.
Note: If you change the AI signal content also remember to change the corresponding
parameters (S6.9.1, 6.9.2) in System Menu.
Figure 4-5: Location of Jumper Blocks in the Control Board of MF4 – MF6, 460V
X9
X8
X13