Eaton SLX9000 - Figure 5-6: Parameter Value Change Procedure

SLX9000 Adjustable Frequency Drives User Manual
MN04003020E
For more information visit: www.eaton.com 5-9
January 2009
The value will not change unless the ENTER button is pressed. Pressing Menu Button Left
takes you back to the previous menu.
Several parameters are locked, i.e. cannot be edited, when the drive is in RUN status. The
drive must be stopped to edit these parameters.
The parameter values can also be locked using the function in menu S6 (see Page 5-16).
You can return to the Main Menu any time by pressing Menu Button Left for 1 to 2 seconds.
The basic parameters are listed in Chapter 6. You will find the complete parameter lists and
descriptions in the Multi-Control Application manual.
Once in the last parameter of a parameter group, you can move directly to the first parameter
of that group by pushing the Browser button up.
Once in the last parameter of a parameter group, you can move directly to the first parameter
of that group by pressing Browser Button Up.
See the diagram for parameter value change procedure in Figure 5-6.
Figure 5-6: Parameter Value Change Procedure
STOP
READY
I/O Term STOP
READY
I/O Term STOP
READY
I/O Term
STOP
READY
I/O Term
STOP
READY
I/O Term STOP
READY
I/O Term STOP
READY
I/O Term
ENTER
reset