Eaton SLX9000 - Figure 5-12: Parameter Locking

SLX9000 Adjustable Frequency Drives User Manual
5-16 For more information visit: www.eaton.com
MN04003020E
January 2009
Security
The Security submenu (S6.5) under the system menu has a function that allows the user to
prohibit changes to the parameters.
Parameter Lock (P6.5.2)
If the parameter lock is activated the parameter values cannot be edited.
Note: This function does not prevent unauthorized editing of parameter values.
Enter the edit mode by pushing the Menu Button Right. Use the Browser buttons to change
the parameter lock status (0 = changes enabled, 1 = changes disabled). Accept the change
with the ENTER button or return to the previous level with the Menu Button Left.
Figure 5-12: Parameter Locking
Keypad Settings
In the Keypad Settings submenu under the System menu, you can further customize your
drive operator interface.
Locate the Keypad Setting submenu (S6.6). Under the submenu, there are two pages (P#)
associated with the keypad operation:
Default Page (P6.6.1)
Here you can set the location (page) to which the display automatically moves as the Timeout
Time (see below) has expired or as the power is switched on to the keypad.
Press the Menu Button Right once to enter the edit mode. Pressing the Menu Button Right
once again makes you able to edit the number of the submenu/page digit by digit. Confirm
the new default page value with the ENTER button. You can return to the previous step
anytime by pushing the Menu Button Left.
Note: If you set a page that does not exist in the menu, the display will automatically move to
the last available page in the menu.
STOP
READY
I/O Term STOP
READY
I/O Term STOP
READY
I/O Term
STOP
READY
I/O Term STOP
READY
I/O Term STOP
READY
I/O Term
ENTER
reset