SLX9000 Adjustable Frequency Drives User Manual
MN04003020E
For more information visit: www.eaton.com 5-19
January 2009
Figure 5-15: HMI Acknowledge Timeout
Number of Retries to Receive HMI Acknowledgement (P6.7.4)
With this parameter you can set the number of times the drive will try receive
acknowledgement if this does not succeed within the acknowledgement time (P6.7.3)
Enter the edit mode by pushing the Menu Button Right. The present value shown starts to
blink. Use the Browser buttons to change the amount of retries. Accept the change with the
ENTER button or return to the previous level with the Menu Button Left.
System Information
In the submenu S6.8 under the System menu you can find drive-related hardware and
software information as well as operation-related information.
Enter the Info menu by pressing the Menu Button Right. Now you can browse through the
information pages with the Browser buttons.
Counters Submenu (S6.8.1)
In the Counters submenu (S6.8.1) you can find information related to the drive operation
times, i.e. the total numbers of MWh, operation days and operation hours passed so far.
Unlike the counters in the trip counters menu, these counters cannot be reset.
Note: The operation time counter (days and hours) always runs when the power is on.
Table 5-9: Counter Pages
Page Counter
C6.8.1.1 MWh counter
C6.8.1.2 Operation day counter
C6.8.1.3 Operation hour counter
STOP
READY
I/O Term
STOP
READY
I/O Term
STOP
READY
I/O Term
ENTER
reset
To Next Page
Loading...
