Eaton SLX9000 - Parameter List; Table 7-2: Basic Parameters (Control Keypad: Menu P2 ➔ B2.1)

SLX9000 Adjustable Frequency Drives User Manual
MN04003020E
For more information visit: www.eaton.com 7-3
January 2009
Parameter List
Table 7-2: Basic Parameters (Control Keypad: Menu P2 ➔ B2.1)
Code Parameter Min. Max. Unit Default Cust. ID Note
P2.1.1 Min. frequency 0.00 Par. 2.1.2 Hz 0.00 101
P2.1.2 Max. frequency Par.
2.1.1
320.00 Hz 50.00 102 NOTE: If f
max
> than the motor
synchronous speed, check
suitability for motor and drive
system
P2.1.3 Acceleration time 1 0.1 3000.0 s 1.0 103
P2.1.4 Deceleration time 1 0.1 3000.0 s 1.0 104
P2.1.5 Current limit 0.1 x I
L
1.5 x I
L
AI
L
107 NOTE: Formulas apply
approximately for drives up to
MF3. For greater sizes, consult
the factory.
P2.1.6

Nominal voltage of
the motor
180 690 V 240V:230V
480V:400V
110
P2.1.7

Nominal frequency
of the motor
30.00 320.00 Hz 50.00 111 Check the rating plate of the
motor
P2.1.8

Nominal speed of
the motor
300 20 000 rpm 1440 112 The default applies for a 4-pole
motor and a nominal size
drive.
P2.1.9

Nominal current of
the motor
0.3 x I
L
1.5 x I
L
AI
L
113 Check the rating plate of the
motor
P2.1.10

Motor cosϕ 0.30 1.00 0.85 120 Check the rating plate of the
motor
P2.1.11

Start function 0 1 0 505 0 = Ramp
1 = Flying start
P2.1.12 Stop function 0 1 0 506 0 = Coasting
1 = Ramp
P2.1.13 V/f optimization 0 1 0 109 0 = Not used
1 = Automatic torque boost
P2.1.14 I/O reference 0 4 0 117 0 = AI1
1 = AI2
2 = Keypad reference
3 = Fieldbus reference
(FBSpeedReference)
4 = Motor potentiometer
P2.1.15 AI2 signal range 1 2 2 390 Not used if AI2 Custom min
>0% or AI2 custom max.
<100%
1 = 0 – 20 mA
2 = 4 – 20 mA
3 = 0 – 10V
4 = 2 – 10V