SM65 Supervisory Module Handbook
32
Copyright © 2004-2009 Eaton Corporation. All Rights Reserved.
IPN 997-00012-35E December 2009
Setting up SMS Text Messaging (Requires SM65 v4 or later)
For additional information see Application Note AN0024. To receive application notes refer to
Worldwide Support on page
65.
► To enable SMS alarm messages
1 Connect the SM65 to a GSM modem (refer to Communications Options on page
30).
2 Connect to the SM65 with DCTools.
3 Go to Configuration > Communications.
4 Click on C to expand SMS.
5 For each cellphone to receive SMS alarm messages set the telephone number and level.
Name is optional.
► To check the DC power system status using SMS
1 From any cellphone write a SMS (text) message starting with "P" or "p" (any following
characters are ignored).
2 Send the message to the SM65 GSM modem telephone number.
3 The SM65 will reply with a DC power system status message.
To Next Page
Loading...
