Eaton SM65 - DCTools and PowerManagerII Setup; Ethernet Setup

Communications
Copyright © 2004-2009 Eaton Corporation. All Rights Reserved.
IPN 997-00012-35E December 2009
33
DCTools and PowerManagerII Setup
For the chosen communications option (see diagrams on page 30) configure the
communications settings in either DCTools or PowerManagerII according to the following
table.
Then check that DCTools / PowerManagerII communicates correctly.
 DCTools is available at www.powerquality.eaton.com/downloads
Properties Direct Connection Ethernet Modem
Comms Enabled True True True
Protocol S3P S3P S3P
Connect Using COM1 Ethernet Select a COM port
S3P Address 0 (Note 1) 0 (Note 1) 0 (Note 1)
Phone Number – – User specific
Modem Logon – –
(Note 2)
Server IP Address – 192.168.33.60
(Note 3)
–
Server Port – 14000 (Note 3) –
Telnet – Cleared (Note 4) –
Note 1:
0 = Broadcast, 1-65279 = individual address
Note 2:
Clear if a logon script is not required for the modem.
Select if a logon script is required. Click the Logon Script button to define.
For more details, see DCTools / PowerManagerII online help (press F1).
Note 3:
Allocated by network supervisor
Note 4:
Some Ethernet interfaces (such as routers) may require this to be set.
Ethernet Setup
Before an SM65 supervisory module can communicate over a TCP/IP network with DCTools
or PowerManagerII, the SM65 must be set up for Ethernet communications.
Use DCTools or the keypad to configure the SM65 for Ethernet communications.
► To configure an SM65 for Ethernet communications from DCTools
1 From the DCTools System Summary (Home) screen, click Configuration
then
Communications
to display the Communications view.
2 Under Ethernet, enter the assigned IP address, subnet mask and gateway address
assigned by the network administrator.
 The network administrator must assign a unique IP address to each SM65 to be connected
to the TCP/IP network.