SM65 Supervisory Module Handbook
36
Copyright © 2004-2009 Eaton Corporation. All Rights Reserved.
IPN 997-00012-35E December 2009
► To clear or change a remote access password:
1 Connect to the SM65 with DCTools (see details on page
30).
2 Go to Configuration > Communications
3 Type a new password into the Remote Access Password field or leave the field blank for no
password control.
4 Click the Apply Changes button.
5 Enter the old password.
► To clear a remote access password from the SM65 keypad:
1 From the Main Display Mode, press 8 to enter Configuration Mode.
2 Press 6 to scroll down to Serial Password.
3 Press 8 to clear the password.
4 Press 9 to return to Main Display Mode.
The password is now permanently cleared. If required, the password must be reset via DCTools.
To Next Page
Loading...
