Maintenance
Copyright © 2004-2009 Eaton Corporation. All Rights Reserved.
IPN 997-00012-35E December 2009
43
Step 3 - Remove the old SM65 from the rack
1 Unscrew the old SM65 from the rack.
2 Pull the SM65 out of the rack to expose the cable connections at the side and
rear.
3 Label then disconnect all the cables from the old SM65.
Step 4 - Power up the new SM65 then connect the remaining cables
1 Connect the power cable to the SM65 connector XS8.
2 Check that the green B Power On LED is on. If not, consult
Troubleshooting on page
38.
Step 5 - Connect the remaining cables to the SM65
Step 6 - Screw the new SM65 into the rack
To Next Page
Loading...
