SM65 Supervisory Module Handbook
46
Copyright © 2004-2009 Eaton Corporation. All Rights Reserved.
IPN 997-00012-35E December 2009
Step 3 - Remove the old SM65
1 Label then disconnect all the cables from the old SM65.
2 Unscrew the four screws that attach the SM65 to the sliders.
Step 4 - Attach the new SM65 to the sliders
Step 5 - Power up the new SM65
1 Connect the power cable to the SM65 connector XS8.
2 Check that the green B Power On LED is on. If not, consult
Troubleshooting on page
38.
To Next Page
Loading...
