16 Tripp Lite by Eaton SmartOnline Series User Guide 614-21325—Rev 01
33..22 LLCCDD DDeessccrriippttiioonn
The LCD screen has 2 lines, each line has 16 characters. The first line shows UPS status, the second line
shows measures.
After 5 minutes of inactivity, the LCD displays the screen saver, and the LCD backlight automatically dims.
Press any button to restore the screen.
Note: If fault or alarm appears, the first line of LCD will cycle between fault/alarm message and UPS mode, see
troubleshooting page for additional information.
Figure 15. LCD Description
LCD mode description
Load/equipment status
ONLINE MODE
LOAD:100% 2700W
ESC
The following table describes the status information provided by the UPS
Note: If other indicator appears, see the troubleshooting for additional information.
Table 4. LCD Operating Modes
UPS Display Description
STANDBY MODE
IN:120V 60.0HZ
Equipment is not powered until button is pressed. The UPS
is Off, waiting for startup command from user.
LOAD:100% 3000VA
ONLINE MODE
The UPS is powering and protecting the equipment. The UPS is
operating normally.
RUNTIME:104MIN
BATTERY MODE
A utility failure has occurred and the UPS is on Battery mode.
The UPS is powering the equipment with the battery power.
Prepare your equipment for shutdown.
LCD Description
To Next Page
Loading...
