Transmission appearance may differ, procedure is the same.
6
Auxiliary Drive Gear Assembly
How To Disassemble the Auxiliary Drive Gear Assembly
Special Instructions
To disassemble, the auxiliary drive gear must be
removed.
Special Tools
Typical service tools are needed
A large pair of snap ring pliers
To Disassemble
1. Lay the front auxiliary drive gear on a clean, flat
surface.
2. From the front auxiliary drive gear hub, use a
screwdriver to pry off the snap ring retainer.
3. From the front auxiliary drive gear hub, remove
the snap ring.
4. Use the front hub as a base and press the drive
gear through the bearing.
5. Remove the retaining ring.
6. Inspect the drive gear O-rings, remove is cracked
or distorted.
1
2
B/20-4
B/20-5
U/15-4
A/20-8
3
4
6
5
To Next Page
Loading...
