Transmission appearance may differ, procedure is the same.
22
Mainshaft Assembly
How to Assemble the Mainshaft Assembly
25. Remove the reverse gear snap ring from reverse
gear hub. Position reverse gear on the mainshaft
against 1st speed gear, align reverse gear splines
with sliding clutch.
26. At this time remove the air line and insert the
mainshaft key. Be careful not to move the gears
while doing this procedure, the limit washers
are unlocked and can rotate which would cause
the gears to drop.
27. Install the mainshaft key snap ring.
28. Remove the mainshaft from the vise.
29. On the shaft front, align the sliding clutch
missing internal spline with the mainshaft key
and install the 4th-Drive gear sliding clutch.
Engage the sliding clutch external splines with
the 4th speed gear clutching teeth.
Final Check
Make sure reverse gear is against 1st speed gear.
Make sure the mainshaft key is in the keyway.
Make sure the 4th speed sliding clutch is engaged into
4th speed gear.
continued
B/24-9
B/25-1
B/25-2
B/25-3
29
28
25
26
26
27
To Next Page
Loading...
