2022.10.7
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
117
TRSM0940 Removal and Installation | Release Yoke and Cross-Shaft(s)
Release Yoke and Cross-Shaft(s) Removal
Note: The Transmission and ECA must be removed prior to
removing the Release Yoke and Cross-Shaft(s).
1. Remove the upper and lower Cross-Shaft mounting
cap screws and lock washers from the Release Yoke.
2. Remove the Cross-Shaft Plug with O-ring.
3. Push the upper Cross-Shaft up out of the Release Yoke
and remove the Yoke.
4. Remove the lower Cross-Shaft and Release Yoke.
To Next Page
Loading...
