122
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
2022.10.7
Cobra Lever | Removal and Installation TRSM0940
Cobra Lever Removal
1. Using a Phillips screwdriver, remove the 4 screws from
the Cobra Lever Housing.
2. Disconnect the 8-way Cobra Lever Harness connector
and remove the Cobra Lever from the housing.
Cobra Lever Installation
1. Connect the 8-way Cobra Lever Harness connector and
place the Cobra Lever into the tower.
2. Using a Phillips screwdriver install the 4 screws into
the Cobra Lever Housing.
To Next Page
Loading...
