230
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
2022.10.7
Main Case Main Shaft with Low Force Gearing Assembly | Disassembly and Assembly TRSM0940
Main Case Main Shaft Assembly with Low Force
Gearing
1. Place the Main Shaft vertical and hold the noise in a
vise or a pilot hole in a piece of wood.
2. Install the first stepped washer. The stepped edge
should be facing down so that it contacts the 4th/5th
sliding clutch. Rotate the washer to lock it into place.
To Next Page
Loading...
